Chinese Web site | English website

    Science News
    Contact Us
    Tel:4000168503
                    13412358413
    Fax:020-86652551
    Email:impexhk@hotmail.com
    Add:Dongguan dongcheng district this.i dragon road section 1 over housing loose source science and technology park in A building on the fourth floor

    business news
    Your present location: Home> News Center>

    The Applicable Scope of Flat Labeling Machine and Its Using

    In the previous article we understand the characteristics of the plane labeling machine and its working principle, then the plane labeling machine suitable for use in what areas? Dongguan Auchan technology is the manufacturer of the best labeling of a company, the following small series to tell you the scope of application of the plane labeling machine and its application skills.
     
    Applicable scope of plane labeling machine
     
    Sticker automatic labeling machine for pharmaceutical, food, light industry, cosmetic and other industries round plastic bottles, glass bottles or similar objects labeling. The machine can automatically complete the sub-bottle, send standard tape, synchronous separation labels, stickers and automatic printing batch number, writing clear.
     
    The Skill of Using the Flat Labeling Machine
     
    Adjustment of the pressure brush device
    The center of the label applicator is centered on the label and is symmetrical on both sides. Standard brush perpendicular to the container surface. The overlapping gap of the pressure brush across the vessel is: a single pressure brush is 10mm ~ 15mm, the combined pressure brush is 5mm ~ 10mm. The position of the cleaning brush from the sponge is 1mm ~ 2mm. Adjustment of the pressure bottle head. The bottle head should be 20 mm below the bottle in the absence of the bottle.
     
    The adjustment of the label box
    When the flat labeling machine is used, the center line of the labeling box, the center axis of the marking station and the label paper are tangent, and the center axis of the target plate is in three lines, adjust the target plate to be tangent to the label paper (0 distance) 1mm ~ 2mm can be. Label paper in the box and the pressure on both sides of the gap should be between 0.8mm-1mm, the gap is too large caused by the standard paper box in the shift box, there inclined standard, the gap is too small will lead to poor standard push. The adjustment of the position of the hook of the standard box: the upper and lower, the right and the right grappling hook are on the same vertical plane and even hard to label the paper. Adjustment of the label feed roller: The label near the top of the label finger can not be crushed when the label presser is pressed to the front of the label box and the label is attached when there is no label.
     
    Adjustment of station
    Platen labeling machine and squeegee rubber roller adjustment: squeegee and rubber roller in the entire length of the gap can not appear, if there is gap can be adjusted by adjusting the eccentric bolt squeegee plate. Cots and the adjustment of the target: target and rubber roller between the only contact without any pressure. Gap is too large, too much glue on the target board, resulting in rejection of plastic. Gap is too small, too tight, will squeeze away the glue, the standard plate side without glue. Practice has proved that the standard plate and the gap between the rubber roller in the 0.1mm ~ 0.2mm for the best. Can be adjusted by the lower roller bearing to achieve, if necessary, the upper roller bearing adjustment.