Chinese Web site | English website

    Science News
    Contact Us
    Tel:4000168503
                    13412358413
    Fax:020-86652551
    Email:impexhk@hotmail.com
    Add:Dongguan dongcheng district this.i dragon road section 1 over housing loose source science and technology park in A building on the fourth floor

    company news
    Your present location: Home> News Center>

    Auchan technology to teach you how to identify the labeling

    Machine failure is inevitable, the labeling machine is the same, the labeling machine failure how to quickly identify the correct location of the fault? Identify the location of the fault can be quickly carried out maintenance, to avoid delays in duration, as to identify the fault location? Auchan technology and we talk about.
    High-speed labeling machine maintenance points a few large, from the composition of high-speed labeling machine for the label station, label boxes, screw, printing devices:
    First, the standard station adjustment
    (1) the adjustment of the squeegee and the roller: the squeegee and the roller can not appear in the whole length of the gap, if there are gaps can be adjusted by adjusting the eccentric screwdriver; (2) roller and target adjustment : The target plate and the rubber roller is only in contact with each other without any pressure. Gap is too large, too much glue on the target board, resulting in rejection of plastic. Gap is too small, too tight, will squeeze away the glue, the standard plate side without glue. Practice has proved that the standard plate and the gap between the rubber roller in the 0.1mm ~ 0.2mm for the best. Can be adjusted by the lower roller bearing to achieve, if necessary, the upper roller bearing adjustment.
    Second, the adjustment of the label box
    (1) The center line of the labeling box, the center axis of the marking station is tangent to the label paper, the center line of the target plate is in three lines, adjust the target plate to be tangent to the label paper (0 distance), then move the labeling box closer to 1mm ~ 2mm (2) the standard paper in the standard box and the pressure on both sides of the gap should be between 0.8mm-1mm, the gap caused by too much paper in the standard box in the shift box, there inclined standard, the gap is too small will cause the push standard is not smooth ; (4) the adjustment of the label supply roller: in the absence of the label (in the absence of the label); (3) the adjustment of the position of the standard box grappling hook: up and down, left and right grappling hook in the same vertical plane and even hard on the standard paper, , The label near the top of the label finger can not be crushed when the label holder is pressed to the front end of the label box and the label is loaded.
    Third, into the bottle star wheel, the bottle star wheel, screw into the bottle adjustment
    (1) in the inlet and outlet star wheel and into the bottle screw to adjust to the standard bottle head pressure shall prevail. First, adjust the bottle into the bottle, when the pressure bottle head just overturned the bottle, the adjustment into the bottle star wheel, the bottle is located in the middle of the star wheel groove; (2) into the bottle screw adjustment: The bottle is located in the middle of the groove into the bottle star, adjust the screw so that the screw into the bottle side of the bottle but not by displacement.
    Fourth, the adjustment of the pressure brush device
    (2) the standard brush perpendicular to the container surface; (3) pressure brush to sweep the container overlap gap: a single pressure brush is 10mm ~ 15mm, the combination of pressure brush is 5mm ~ 10mm; (4) cleaning brush from the location of the sponge 1mm ~ 2mm.
    Causing high-speed labeler failure can be found from the above four reasons, only identify the fault location, repair it can really be twice the result with half the effort.